• Feeder Length - Cu - Cast Resin

    Feeder lengths can be supplied at any length from 500mm - 4000mm.

  • Flatwise Elbow - Cu - Cast Resin

    Flatwise and edgewise elbows are used to make 90° changes in the direction of the busbar system.

  • Edgewise Elbow - Cu - Cast Resin

    Flatwise and edgewise elbows are used to make 90° changes in the direction of the busbar system.

  • Edgewise Offset - Cu - Cast Resin

    An offset is used to avoid obstacles such as pipes or steel columns and to conform to the structure of the building.

  • Flatwise Offset - Cu - Cast Resin

    An offset is used to avoid obstacles such as pipes or steel columns and to conform to the structure of the building.

  • Edgewise Flatwise Offset - Cu - Cast Resin

    Combination elbows are used to conform to the building structure and to utilise a small amount of space to change direction.

  • Flatwise Edgewise Offset - Cu - Cast Resin

    Combination elbows are used to conform to the building structure and to utilise a small amount of space to change direction.

  • Flatwise Tee - Cu - Cast Resin

    Flatwise tees are used to split one busbar run into two runs going in different directions. This reduces the amount of space needed when supplying two different parts of a building.

  • Joint Block - Cu - Cast Resin

    The Powerbar joint pack is a compression join design which utilises a specially designed Belleville washer to distribute the pressure evenly over the joint pack.

  • Spring Hanger - Cast Resin

    Spring hangers are used to support vertical busbar runs on each floor. They compensate for building movement and thermal expansion.

  • HPB-CRB Transition Box - Cu