• Feeder Length - Al - Cast Resin

    Feeder lengths can be supplied at any length from 500mm - 4000mm.

  • Flatwise Elbow - Al - Cast Resin

    Flatwise and edgewise elbows are used to make 90° changes in the direction of the busbar system.

  • Edgewise Elbow - Al - Cast Resin

    Flatwise and edgewise elbows are used to make 90° changes in the direction of the busbar system.

  • Edgewise Offset - Al - Cast Resin

    An offset is used to avoid obstacles such as pipes or steel columns and to conform to the structure of the building.

  • Flatwise Offset - Al - Cast Resin

    An offset is used to avoid obstacles such as pipes or steel columns and to conform to the structure of the building.

  • Edgewise-Flatwise-Offset-Aluminum_CastResin

    Combination elbows are used to conform to the building structure and to utilise a small amount of space to change direction.

  • Flatwise-Edgewise-Offset-Aluminum_CastResin

    Combination elbows are used to conform to the building structure and to utilise a small amount of space to change direction.

  • Flatwise-Tee-Aluminum_CastResin

    Flatwise tees are used to split one busbar run into two runs going in different directions. This reduces the amount of space needed when supplying two different parts of a building.

  • Joint Block - Cu - Cast Resin

    The Powerbar joint pack is a compression join design which utilises a specially designed Belleville washer to distribute the pressure evenly over the joint pack.

  • Spring Hanger - Cast Resin

    Spring hangers are used to support vertical busbar runs on each floor. They compensate for building movement and thermal expansion.

  • HPB-CRB Transition Box - Al